Scanrouter updating destination list failed
I have scan to folder setup and working on a Savin C5050.
Is there any way to get rid of this notification/error on the copier "Updating the destination list has failed. We are using scanrouter lite for 3 older copiers, this copier is not listed as an I/O device. It sounds like maybe the authentication has changed on the delivery server, as in the username or password.
Trying to get it setup to either scan to folder or scan to email.
Im getting the same error as above and no, there is no setting that allows you to turn off the delivery server (at least not in the areas you suggested). It was on a screen I would not have thought to check since the ip was 0.0.0.0. It sounds like a setting has been turned on accidentally on the machine itself.
The memory device is full and scan data cannot be saved.
Even if the memory device appears to have sufficient free space, data might not be saved if the maximum number of files that can be saved is exceeded. This message might reappear if the machine is operating on a mixed network or if changes were made to network settings during WSD scanning transmission.
It would be a different email address though for me to communicate with you.Press the yellow button, then 1 0 7, then hold the stop key(red/orange button) for more than 5 seconds until the screen changes, select the first option which should be "copy" or "system", then press 5 8 3 2 #, then select "execute", this will format the HDD/hard drive, then switch off and on, input your addresses again and all will be fine.Hi, A 6ya expert can help you resolve that issue over the phone in a minute or two.Jonathan was a young Christian man raised in a conservative Baptist Church.